
Karcher Pressure Washer Spares
If you require a replacement seal, clamp or hose for your Karcher appliance we are sure to have something for your needs.
If you are unsure of your Karcher appliance's model number, take a look at our handy guide on where to find the model number for your appliance here.
Karcher Pressure Washer: 1 - 12 of 2667
Karcher Set Back Foot
Genuine spare part
Replace a cracked or damaged back foot for your pressure washer with this genuine replacement and restore your cleaner's performance. Please check... More information
Karcher Vacuum Cleaner Wet & Dry Cartridge Filter
BuySpares Approved part
Height: 115 (mm) Diameter: 120 (mm) If your vacuum cleaner has lost its suction power, you may have clogged up and worn out filters. Replace them... More information
Save 10% if you buy 2 or more - only $9.92
$11.02
Save 10% if you buy 2 or more - only $9.92
Karcher 7.5m Hose & Handgun
Genuine spare part
PLEASE NOTE: Suitable for K2 - K7 series pressure washers EXCEPT barrel & intergrated hose reels models, if you are not sure please see check the... More information
Karcher Water Intake Clamp
Genuine spare part
If the clamp clip holding the water intake tube has perished and it can no longer perform the job its intended for then you will want to replace it.... More information
Karcher High Pressure Hose - 4m
Genuine spare part
4m hose length Pressure: 120 Bar Temperature: 40°C Your pressure washer releases a narrow stream of water at a very high pressure. The water hits... More information
Karcher High Pressure Outlet
Genuine spare part
This genuine replacement High Pressure Outlet connects to the pump inside your Karcher K4 pressure washer. High pressure outlets can often crack... More information
Karcher Grooved Ring - Seal
Genuine spare part
If the grooved ring seal in your pressure washer pump has snapped or worn out, help ensure optimum performance once again with this quality replacement.... More information
Karcher K2 Pistol Clamp
Genuine spare part
Colour: Yellow Ensure your pressure washer hose is secure to the hand gun with this genuine replacement Pistol Clamp! A damaged pistol clamp may cause... More information
Karcher Hose Connector
Genuine spare part
3/4" Your pressure washer increases the water pressure from a standard water spigot to over 1,000 PSI, so the water pressure can be used to remove... More information
Karcher Pressure Washer O-Ring Kit
Genuine spare part
For simple replacement of O-rings and safety plug on pressure washer accessories 16 x O-rings (across 5 sizes) 4 x Yellow rubber stoppers The O-Ring... More information
Karcher Spray Lance Extension - 0.5m
Genuine spare part
Extends spray lance by 0.5m Effective cleaning of difficult to reach areas Unlimited pressure adjustment Low pressure detergent Dimensions : L:445... More information
Karcher Form Seal
Genuine spare part
This replacement Form Seal is located on the pump of your pressure washer and sits between the cylinder head and control piston. If you notice that... More information